Home > Raspberry PI > Raspberry PI > HC-SR501 Infrared PIR Motion Sensor Module for Arduino Raspberry p

HC-SR501 Infrared PIR Motion Sensor Module for Arduino Raspberry p

HC-SR501 Infrared PIR Motion Sensor Module for Arduino Raspberry p

HC-SR501 Infrared PIR Motion Sensor Module for Arduino Raspberry p
Details
SKU HC-SR501 Infrared PIR Motion Sen
Weight 1.00 lbs
 
Market price: $14.99
Our price: $6.99
Options
Quantity

HC-SR501 Infrared PIR Motion Sensor Module for Arduino Raspberry p

IN STOCK

Dimension: 3.2cm x 2.4cm x 1.8cm (approx)
Infrared sensor with control circuit board
The sensitivity and holding time can be adjusted
Working Voltage Range: DC 4.5V- 20V
Current drain:<60uA
Voltage Output: High/Low level signal:3.3V TTL output
Detection distance: 3--7M(can be adjusted)
Detection range: <140°
Delay time: 5-200S(can be adjusted, default 5s +-3%)
Blockade time: 2.5 S (default)
Trigger: L: Non-repeatable trigger  H: Repeat Trigger (default)
Work temperature:-20-+80°C
Trigger Method: L unrepeatable trigger / H repeatable trigger
53%
: *
: *
: *
Type the characters you see in the picture:


*
 
Raspberry Pi 3 Model B SBC 5 inch HDMI TFT LCD Touch Screen for Raspberry PI 3B/ 2B / B+ / A+ / B 2.4G Wireless Mini Keyboard For Raspberry / Banana Pi
$44.99
$39.99
$19.99
 
USB Controller Gamepads PC Controllers Joypad Joystick Raspberry pi 3 Raspberry Pi 3 Model B 40 Pin GPIO Adapter Extension Board 1 to 3 40 Pin Plate Module GPIO Adapter for Orange Pi
$9.99
$6.99
iJust 2 Kit - e-cigarette Xbox 360 Wireless Controller PSTwo/PS2 Magic Switch v4 w/ Swap Magic Plus v3.8 Coder CD/DVD
$17.99
$34.95
$19.95

Product rating

Sign in to rate

Customer Reviews

There have been no reviews for this product.
No news available at the moment
I preordered a wasabi 360 slim and got it last month. It installed very easily and with the latest firmware v1.2beta3 it extracted my DVD .bin within seconds. I have used modchipcentral for years and sometimes they are a couple dollars higher but they are quality!! You know you are getting what you pay for and not getting a cheap look a like.I would like to add to the firmware extraction step. When you are ready to get your firmware you must push and hold the small green up arrow located around the left button on the slim console before you turn on the Xbox,then turn on the Xbox and continue to hold it until the Xbox comes on this only took 10seconds tops. Also when you are installing this MAKE sure the power cable is oriented the right way(the end with the extra small 2 cords should plug into the DVD drive so they can reach the wasabi and give it power. The 2 small cords will not reach if you mess up on this step.
Tommy Caldwell

View All Testimonials

Write Your Own Testimonial
Latest Products RSS Feed
Bestselling Products RSS Feed
Featured Products RSS Feed
Specials RSS Feed